Remote Control Systems
PAGE: 6
200, 400, and 500 Series
Remotes-0214
2721 NE 4th Ave Pompano FL 33064 | (954) 367-6116
Visit WWW.ACIHOIST.COM for the most current information
2.2 Operating Precautions
2.2.1 Attention
1.
Due to the complex nature of equipment, it is necessary to read the entire manual before installation.
2.
Never allow any unauthorized personnel to dismantle equipment as this may cause equipment damage.
3.
The equipment has been stringently tested for quality assurance before delivery from factory. However, it must
not be used in extremely dangerous situations or where damage may result.
4.
After operation, switch off crane main power as well as receiver unit and remove rotary key from transmitter unit.
5.
Keep the transmitter in a safe place when not in use to avoid any unintentional operation.
6.
The crane should be equipped with a main power relay, limit switch, and other safety devices required.
7.
Do not use this device during an electrical storm or where there are conditions of high electrical interference.
8.
Always check transmitter batteries and receiver input power condition before operation.
9.
The installation and maintenance service is allowed only when the crane and receiver power are off to avoid
electrical shock.
10.
The contents of the manual may be ammended by the manufacturer without notice.
11.
The specification and function is subject to change without notice by manufacturer.
2.2.2 Precautions (500 Series)
1.
Press EMS button and switch off main power of crane and receiver after operation. Then, remove transmitter
rotary key and keep in a safe place.
2.
The following may cause receiver response delay and you should stop operation immediately when these
situations occur.
a.
Beyond operating range.
b.
During severe radio interference.
3.
Remove transmitter batteries when not in use for a long period of time.
4.
To extend product life, please follow the standard operating procedure and maintain system regularly.
2.2.3 Emergency Procedures (500 Series)
In case of emergency, please follow the procedure below:
5.
Press EMS button and stop operation.
6.
Switch rotary key to “OFF” position and remove it from transmitter unit.
7.
Switch off crane main power.
8.
Contact the authorized distributor for further assistance.