Remote Control Systems
PAGE: 31
200, 400, and 500 Series
Remotes-0214
2721 NE 4th Ave Pompano FL 33064 | (954) 367-6116
Visit WWW.ACIHOIST.COM for the most current information
10.0 TROUBLESHOOTING
Item
Problem
Cause
Action Required
1
Red LED flashing quickly (every
0.2 sec.) when any motion
pushbutton is pressed.
A) One of the push- buttons is
jammed.
B) The system is not properly
powered according to the
instructions.
A) Replace the pushbutton.
B) Power on again
according to the
instructions.
2
TX LED flashes red and yellow
reciprocally and slowly (every
0.5 sec).
The memory of the TX
is defective.
Send back to the
manufacturer.
3
TX LED flashes red every 2
seconds when any motion
pushbutton is pressed.
The transmitter batteries are at
low power.
Replace the 2
AA size Alkaline batteries at
once.
4
RX Error LED flashes red slowly
(every 0.5 sec.).
The memory of the RX
is defective.
Send back to the
manufacturer.
5
The operating dis- tance is
shorter or an intermittent
operation is happening.
It was interferred by other
Radio Remote Controller or
unknown signal with the same
frequency.
Replace the crystal of both
TX and RX to change the
frequency.
Remark: The memory of the TX and RX has anti-copy function design. Any improper decoding of the firmware
of the memory will cause the problems as the above items 2 and 4.
If any problem cannot be solved or if you have any questions or suggestions, please call (866) 424-6478.