8
9
Introduction to Control &Display Panels
Mode Switch Button
One press for ECO mode: the
machine will adjust the wind speed
based on the environment
temperature.
Twice press for Sleep Mode: the
machine will enter sleep scenario.
Three times press for Turbo Mode:
the machine will enter Turbo mode,
adjusting the wind speed to the
maximum level with one press.
Remote Control Instructions & Installation
Replacement & Storage of the remote control.
Control panel of the host
Using the remote control
1. Press place
➊
while
holding place
➋
to pull
out the battery buckle.
2. Please replace the battery with new one
(CR2032), keep the positive side facing
upwards, and push the buckle in to
complete the replacement of the battery.
(CR2032 button-type lithium battery is applicable)
3. Place the remote
control by the magnet
on the head for storing
when not in use.
Up to 10m
Precautions for battery usage
1. When pulling out the battery shackle, please pull it out slowly and do not tug on it forcefully to
prevent the battery from falling out of the shackle.
2. The batteries might be hazardous. Please keep batteries away from children.
3. If fluids leaked from the battery accidentally splashed into the eyes, do not rub the eyes; rinse the
eyes thoroughly with clean water, such as tap water, then seek medical attention immediately.
Please note that this may cause blindness.
4. If fluids leaked from the battery accidently got on the skin and clothes, please wash it of
immediately with clean water, such as tap water. Please note that this may also cause dyeing.
5. If you need to dispose of the battery, please follow the local waste sorting requirements (and use
clear tape to wrap both the “+” and “-” sides)
Remote control precautions
1. The remote control must point directly to the signal receiver.
2. The usage range of the remote control is approximately within 10m to the front of the
receiver; if the remote control is not faced towards the receiver, its usage range will be reduced.
3. Do not place any obstacles between the receiver and the remote control.
4. Please keep the remote control properly; avoid impacts and dropping. Please remove the
battery when not using the remote control, and keep it in a safe place.
Remote
control
receiver
Power ON/OFF
Press to start or stop using
this product.
1
2
3
Child Lock Mode
1. Press mode switch button for 3
seconds,the machine will activate the
child lock. Once users touch the control
panel & remote, “SAFE” will be showed on
the screen to indicate child lock status. To
unlock the mode, please press for 3 secs
again.
2. The power button can still be operated
under child lock status, so users can still
turn off he machine under child lock
mode.
3. Under this mode, users need to long press
Mode switch button for 3 secs to unlock
the machine before turning on the power.
4. Childlock can only be turned on/off on
the control panel, not on remote control.
Speed Adjustment
Button-increase
Use this button to adjust the
wind speed; One press for one
level speed up (the adjustment
range is from level 1-16.)
*When the speed is at the max level
16,one more press will go back to
the min level 1 speed.
Speed Adjustment
Button-decrease
Use this button to adjust the
wind speed; One press for one
level speed down (the
adjustment range is from level
1-16.)
*When the speed is at the min level
1,one more press will go back to the
max level 16 speed.
1
2
3s
Summary of Contents for cozy Series
Page 9: ...Memo...
