acerpure clean Lite HV312-10W, User Manual

Page: 8 / 36

8
Attach the HEPA and metal filters to the
vacuum cleaner and turn them in the
clockwise direction for tightening.
You can change the vacuum head depending on the
cleaning requirements. Remember, a “click” must be
heard to signal assembly is done.
Install the dust box until a “click” is heard to finish the
vacuum cleaner assembly. Press the power button to
start using the product.
• Insert the charging adapter to the charging port on the
side of the product and connect it to a USB slot. (The
vacuum cleaner can be charged with a charger with an
output of 5V, 2A-4A.)
• Approximately 4 hours is needed to fully charge the
battery. The indicator will keep flashing during charging.
Once charging is completed, the indicator will stay on for
5 minutes before turning off to save power.
• When the power level of the battery is more than 10%, the
indicator will stay on.
• When the power level of the battery is less than 10%, the
indicator will flash slowly to alert you that the power level
is low and immediate charging is required.
• When the battery is depleted or over discharged, the
indicator will flash continuously for 10 seconds before the
vacuum cleaner stops discharging and working. Charging
is required for it to resume operations.
Product Assembly and Charging
Other Vacuum
Head Assembly
Product Charging
1
2
Power button
[2-in-1 Vacuum Brush assembly] [Floor head and extension
tube assembly]
Make sure to charge the product on a regular basis to maintain
the battery life. Before charging, check if the product is off.
Only use a USB to Type C charging cable to charge the product.