51
Chapter 3
Opening the Housing
This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION:
Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Housing Cover
1.
Place the system unit on a flat, steady surface.
2.
Turn the housing back.
3.
Remove the two screws using a screw driver from the rear panel as shown here. Set the screws aside,
you will need them when replacing the right panel of the unit.
4.
Slide the upper case back out about an inch and then gently pull it outward to detach it from the housing.
Summary of Contents for Veriton 3200
