![background image](http://html.mh-extra.com/html/acer/veriton-3000/veriton-3000_service-manual_6262097.webp)
Chapter 4
65
How should I begin troubleshooting?
If you see an error message, find the message in the “List of POST Error Messages” on page 67
and take the
corrective action(s) indicated.
If you did not receive an error message, look for a description of your error symptoms in the “List of Error
Symptoms” on page 70
and take the corrective action(s) indicated
.
If you receive error beeps while flashing the BIOS using the boot block function, refer to the “List of Error
Beeps for BIOS Boot Block Flash” on page 76 to find the corrective actions.
If you are unable to correct the problem by using the above information, go to “ Undetermined Problems” on
page 77.
NOTE: After you have deemed it necessary to replace an FRU, and have done so, you must then run a total
system check to ensure that no other activity has been affected by the change. This system check can
be done through the diagnostics program.
NOTE: Check all power supply voltages, switch, and jumper settings before you replace the main board. Also
check the power supply voltages if you have a “system no-power” condition.
Here is a list of the troubleshooting information in this chapter:
T
“Power-on Self-Test (POST)” on page 66
T
“List of POST Error Messages” on page 67
T
“List of Error Symptoms” on page 70
T
“List of Error Beeps for BIOS Boot Block Flash” on page 76
T
“Undetermined Problems” on page 77
Troubleshooting
Chapter 4
Summary of Contents for Veriton 3000
