Downloaded from Projector.com
0DLQWHQDQFH
$FHU 6OLP
Lamp Replacement
Caution
To reduce the risk of electrical shock, always turn off the projector and disconnect
the power cord before changing the lamp.
1. Press the POWER button to switch off the projector and disconnect the power
cord from the outlet.
2. Loosen the screw and remove the lamp cover. If the lamp is hot, avoid burns by
waiting 45 minutes until the lamp has cooled.
3. Loosen the 3 screws indicated by the arrows above. (It is strongly
recommended you use a magnetic-headed screwdriver, if possible. Pull the
handle to remove the lamp housing. If the screws are not loosened completely,
they could injure your fingers. Do not insert your hand into the box after the
lamp is removed. If you touch the optical parts inside, this could cause color
unevenness, etc.
4. Replace the lamp with the new one. Insert it in the projector, and tighten the
screws firmly. Loose screws may cause a bad connection, which may result in a
malfunction.
5. Re-install the lamp cover and tighten the screw. Do not turn on the power with
the lamp cover removed. Whenever the lamp is replaced, reset the total lamp
operation time. Do not reset if the lamp is not replaced as this could cause
breakage.
