vii
System Tour
1
Features
1
Block Diagram
4
System Components
5
Front Panel
5
Rear Panel
6
Hardware Specifications and Configurations
7
Power Management Function(ACPI support function)
10
System Utilities
11
CMOS Setup Utility
11
Entering CMOS setup
12
Navigating Through the Setup Utility
12
Setup Utility Menus
13
System Disassembly and Assembly
23
Disassembly Requirements
23
Pre-disassembly Procedure
24
Removing
the Computer Stand
25
Removing
the Top Cover
26
Removing
the Optical Disc Drive
27
Removing
the ODD Base Cover
30
Removing
the Sheet Metal
32
Removing the Heat Sink Fan Assembly
33
Removing the Memory Modules
35
Removing the Daughter Board
36
Removing the Wireless LAN Card
37
Removing the Main board
39
Removing the Hard Disk Drive
41
Removing the LED Lens
42
Removing the Battery
43
Removing the IR Sensor Cable
44
Removing the WLAN Antennas Cable
45
Removing the South Bridge Heat Sink
46
Assembly Requirements
47
Installing the Hard Disk Drive
48
Installing the WLAN Cable
50
Installing the Memory Modules
51
Installing the LED Lens
52
Installing the South Bridge Heat Sink
53
Installing the Antennas of WLAN Card
54
Installing the IR Sensor Cable
55
Installing the Main Board
56
Installing the Heat Sink Fan Assembly
58
Installing the Daughter Board
60
Installing the Sheet Metal
61
Installing
the Optical Disc Drive
62
Installing
the Top Cover
66
Installing
the Computer Stand
67
Table of Contents
Summary of Contents for RL70
