Confidential
4-9
K130
Inspection item:
-
Check if there is lines or noise on the screen.
-
Horizontal and vertical position of the video should be
adjustable to the screen frame.
Criteria:
-
If there is noise on the screen, the product is
considered as failure product.
-
The screen appears normal, it shouldn’t appear any
abnormal condition, such as lines and so on.
-
Check if the projection is same as monitor displayed.
2. Fan Calibration
Note: - To store the value of fan in main board, after replacing main board,
fan or upgrading the firmware,the “Fan calibration” is needed.
Procedure
- Hold on the “Power” key and plug in the power
adapter, When the power LED flash red, release the
“power” key, The project will power on after about 2s.
- Press "Power", "Left", "Left" and "Menu"
buttons sequentially to get into Service Mode
to check the fan speed if it has been recorded.
Note: The value of “Factory Blower RPM” should be around 6450~7200 rpm.
3. LED Calibration
Note: - To avoid color abnormal,after replacing main board, Engine Module ,
the “LED calibration” is needed.
-
LED Calibration Fixture PN: 80.8KT11G001-A .
1.Procedure
- Press “Power”-->“Left”--> “Left”-->“Menu” to get
into Service Mode.
- Select “LED Calibration Settings”
- Enter in LED Calibration Settings , and select
“Reset Calibration Data”
2.If the color still appears abnormal, please execute below procedure:
- Put the CL200 on the center of the screen which
6700
Must be on the center of the screen
CL200 RS232 Cable
LED Calibration Fixture
Summary of Contents for K130 Series
