Acer Aspire 8951G, Service Manual, Page: 105 / 260

Machine Maintenance Procedures
3-13
Main HDD (Hard Disk Drive) Module Removal
0
Prerequisite:
Battery Cable Removal
1. Locate main HDD module (C) on lower cover. ( Figure 3-7 )
CAUTION :
!
HDD module is connected to mainboard. Use caution when removing module.
2. Use mylar tabs (A) to lift HDD module until HDD cable clears lower cover. (Figure 3-9)
Figure 3-9. Lifting Main HDD Module
3. Disconnect HDD cable (B) from HDD module connector.
4. Remove HDD module.
5. Repeat Steps 1 through 4 for Secondary HDD Module as required.
HDD Module Installation
0
1. Connect HDD cable (B) to HDD module connector. (Figure 3-9)
2. Install HDD module into bay on lower cover.
3. Install logic door.
4. Repeat Steps 1 through 3 for Secondary HDD Module as required.
A
B
A