6 Troubleshooting
88
•
Are the power supply cables properly connected to the server
board?
•
Are there any shorted wires caused by pinched cables or have
power connector plugs been forced into power connector sockets
the wrong way?
Floppy disk drive activity light does not light
Check the following:
•
Are the floppy disk drive's power and signal cables properly
installed?
•
Are all relevant switches and jumpers on the floppy disk drive set
correctly?
•
Is the floppy disk drive properly configured?
•
Is the floppy disk drive activity light always on? If so, the signal
cable may be plugged in incorrectly.
If you are using the onboard floppy disk controller, use the BIOS setup
to make sure that "Onboard Floppy" is set to "Enabled." If you are
using an add-in floppy disk controller, make sure that "Onboard
Floppy" is set to "Disabled."
CD-ROM drive or DVD-ROM drive activity light
does not light
Check the following:
•
Are the CD-ROM/DVD-ROM drive's power and signal cables
properly installed?
•
Are all relevant switches and jumpers on the drive set correctly?
•
Is the drive properly configured?
Cannot connect to a server
•
Make sure the network cable is securely attached to the correct
connector at the system back panel.
•
Try a different network cable.
•
Make sure you are using the correct and the current drivers.
•
Make sure the driver is loaded and the protocols are bound.
Summary of Contents for Altos G310 MK2 Series
