![background image](http://html.mh-extra.com/html/acer/acerpower-sn/acerpower-sn_service-manual_5788059.webp)
Chapter 4
51
POST Error Messages List
If you cannot run the diagnostics program tests but did receive a POST error message, use “POST Error
Messages List” to diagnose system problems. If you did not receive any error message, look for a description
of your error symptoms in “Error Symptoms List” on page 53
.
NOTE: When you have deemed it necessary to replace an FRU, and have done so, you must run a total
system check to ensure that no other activity has been affected by the change. This system check can
be done through the diagnostics program.
NOTE: Check all power supply voltages, switch, and jumper settings before you replace the system board.
Also check the power supply voltages if you have a “system no-power” condition.
If you are unable to correct the problem by using the “BIOS Messages List” table and “Error Symptoms List”
table, go to “Undetermined Problems” on page 57.
NOTE: To diagnose a problem, first find the BIOS error messages in left column. If directed to a check
procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the
first Action/FRU listed in right column is the most likely cause.
BIOS Messages
Action/FRU
I/O Parity Error
System board
CPU Clock Mismatch
Enter BIOS Setup and load the default settings.
Ensure the jumper setting for processor is set correctly.
Real Time Clock Error
CMOS Battery Bad
CMOS Checksum Error
Enter BIOS Setup and load the default settings.
RTC Battery.
System Board.
Equipment Configuration Error
Ensure the system configuration set in BIOS Setup is
correct.
Enter BIOS Setup and load the default settings.
RTC battery.
System board.
Memory Size Change
System Management Memory Bad
Memory Error at MMMM:SSSS:OOOOh
Insert the memory modules in the DIMM sockets
properly, then reboot the system.
Memory module.
System board.
RAM Parity Error
Enter BIOS Setup to disable parity check.
Memory module
System board
PS/2 Keyboard Error or Keyboard Not Connected
PS/2 Keyboard Interface Error
PS/2 Keyboard Locked
Re-connect PS/2 keyboard and mouse.
Enter BIOS Setup and load the default settings.
PS/2 keyboard
PS/2 mouse
System board
Onboard xxx... Conflict(s)
Enter BIOS Setup and load the default settings.
Remove all adapter cards that are NOT factory-installed,
then reboot the system.
Floppy Disk Controller Error
Floppy Drive A Error
Floppy Drive B Error
Diskette drive cable/connection.
Diskette drive.
System board
On Board Parallel Port Conflict(s)
On Board Serial Port 1 Conflict(s)
On Board Serial Port 2 Conflict(s)
Enter BIOS Setup and load the default settings.
Remove all adapter cards that are NOT factory-installed,
then reboot the system.
Summary of Contents for AcerPower SN
