27
The configuration command is not effect whether the unit is open or close until the unit receive the
new command.
1
．
Three steps to send the GPS Position of unit to Platform
1). Set up the access point name of GPRS
1 Format1
：
#803#user password#APN##
eg
：
#803#0000#CMNET##
Format2
：
#803#user password#APN#APN user name#APN password ##
Explanation1: Different GSM / GPRS service associations provide different APN, please according
to local service providers to provide the APN to choose format 1 or 2 to use set.
Explanation2: When ACE-TL210 tracker receives the instruction and confirms the user password
correctly, updates the access point name to the new access point name. After the success, it will send
the confirmation messages to the sender. If sent the format 1, the content is “SET GPRS APN OK”; if
it is format 2, the content is “SET GPRS ACCOUNT OK”.
Note: APN is CMNET after factory set or reset. APN is characters composed of 3 to 35 letters,
numbers, dots (.) underscore (_) and connectors (-). APN user name and user password are
respectively characters composed of from 3 to 20 the numbers and letters.
2). Set up the TCP/IP server and IP’s address and port number
Format
：
#804#user password#fixed IP address # port ##
eg
：
#804#0000#222.125.12.32#80##
Explanation: When ACE-TL210 tracker receives the instruction and confirms the user password
correctly, updates the IP address and port number preserved in the module
，
After the success, it will
send the confirmation messages to the sender. The content is “SET SERVER IP AND PORT OK”
3). Upload Data Settings Automatically
There are two mode about Upload Data Automatically. One is "Car Moving Tracking Mode".
Another is "Car Stop Tracking Mode". Both of this two mode is change automatically due to the
ACC State . The ACC is open and it's "Car Moving Tracking Mode". The ACC is close and it's "Car
