9/
2
8
/20
22
ACE120
14
Memory
Location: The Vision Series model can contain up to 4 DIMMS of memory. The memory modules
are found on the motherboard to the right of the heat sink fan, refer to Figure 1 for additional
guidance.
Type and number of fastenings: Two (2) latches per memory module.
Tools required: None.
Procedure:
Step 1: Ensure the desktop is off, unplugged, and any potential energy is dissipated.
Step 2: Remove the side panel from the chassis as indicated in the “Chassis Cover” section of this
manual.
Step 3: After locating the memory, press both release tabs on the ends of the memory module
to unlock the carriage. Use gentle, even force, on either side of the memory module to remove
from the memory slot.
Step 4: Repeat Step 3 for each piece of memory in the system.
Reinstallation
Step 5: Using the graphic, to
install new or additional
memory DIMMS, open the
latch, and gently push down,
with equal pressure
distribution on both sides of
the memory module. Ensure
the memory is fully engaged,
then reengage the latch to
secure the memory in place.
Disposal:
Selective Treatment/Special Handling Per Annex VII, Directive 2012/19/EU: The memory
module is a printed circuit board of greater than 10 sq. cm and must be removed from
the device and must be disposed of, or recovered, in compliance with the requirements of
Directive 2008/98/EC.
