7
3.2
Electrical Installation
Find a good route for the cable to the front of
the vehicle or to the area where it will be
connected to the vehicles electrical system.
The principal idea for the routing of the cable
loom is as follows: cable should run under the
vehicle to a place where you can enter the
vehicle. Try to find a dry place for the 4 pin
connector in the cable loom inside the vehicle
There are two possible operations of the
step.
1 - Door switch. Steps moves out
automatically when the door opens
2 - Driver operated switch on the dashboard
where the driver operates the step. In this
case, it is still recommended that the door
switch in installed. Without the door switch
the driver could forget to close the step when
the door is closed, and drive away with an
open step.
Connect the green wire at the handbrake
switch or other signal indicating that the
vehicle is stationary. You need a signal
when the vehicle is stationary. The
handbrake switch is not supplied with the
step.
For safety reasons we recommend this
signal is used.
If you decide not to use this
signal Acdeos cannot
take any responsibility
for any unsafe
operation of the step.
Cable colours:
black
Ground
Red
Power (Use a 20 Amp
fuse)
Green
Ground signal for
operating the step
