1
English
1
English
-9
INSTALLING ACCESSORIES
1.
Turn off the tool.
2.
Depress the spindle lock button (see under A.) and slowly turn the collet nut (see
under B.) until the spindle lock button locks the spindle.
3.
While holding the spindle lock button down, turn the collet nut counter-clockwise
using the wrench (see under C.) until the collet is loose inside the collet nut.
4.
Insert the accessory shank (see under D.) into collet as far as it will go.
Make sure the correct collet is used for the accessory. If collet is too large,
replace the collet with the next smaller size.
5.
Press the spindle lock button and engage it in the spindle. Whilst holding the
spindle lock button downtighten the collet by turning it clockwise using the
wrench until it is as tight as you can make it by hand.
Do not use pliers to tighten the collet nut. Use the small wrench supplied.
Over
tightening will cause damage to the tool.
6.
Pull on the accessory to ensure it is securely in place.
NOTE
NOTE
A
B
C
D
Lock
Loose
