ACDC 12V Air Conditioner
Cool Air While Keeping the Earth Clean
5
2.
Installation
Unpack the shipping box and check if the equipment is damaged, missing, or
misplaced. The overall assembly is very simple and straightforward and can be done
independently.
2.1
Mount Outdoor Unit
The outdoor unit is mounted on backside of the truck. Special installation equipment is
required to mount the unit on the outer wall. First, mark the hole positions according to
the corrugated template (see below). There are 4 hole marks at 0.5” from the edges of
the corrugated template and another 4 hole marks at 4.25” apart from the outer hole
marks. Inner hole marks are reserved optional for the wall-mounted orientation. Drill
holes that are just large enough to slide the rivet nuts into. Drill bit size of 11mm (7/16”)
is recommended for M8 rivet nuts. You may Rubber gaskets have already been
attached on the bottom of the 4 fixture legs. Keep the distance between the outdoor
unit and the indoor unit within 3m so the refrigerant hoses and electrical cable can
reach each other.
Figure. Overlapping the corrugated template on the outdoor unit
2.2
Mount Indoor Unit
The indoor unit is mounted inside the cab on the rear or side wall
. Maintain the level so
the water can be drained properly. First, use the wooden board to provide a level surface. Open
the connector-retaining caps. You should be able to hear a hissing sound when you open them.
0.5”
16.5”
33.5”
4.25”
1”
Corrugated template
33.5” x 16.5”
Outdoor unit
4 5/16”
7 7/8”
