www.accutrolllc.com
2
ZPS-H QUICK START GUIDE Rev. L 11/4/2020
1c. Mounting
Install the circuit board under the screw heads shown below. Carefully hand tighten the screws in the position shown.
1d. Wiring
Connect the cable terminal block to the pins in the upper left corner of the ZPS-H sensor board and pull any extra cable
through the hole. Route the cable to avoid moving hood sash components.
Reference the wiring diagram pictured below
Connect the red and black wire from the ZPS-H to the power supply shared with the AVC controller.
Connect the brown and white wires from the ZPS-H to the AVC at DI-1.
WIRING TABLE
ZPS-H
AVC
RED
24V (+)
BLACK
24V (Gnd)
BROWN
DI-1 (1)
WHITE
DI (Gnd)
GREEN
No
Connection
Slotted holes
fit over screws
ZPS-H
RED: 12-24 V AC/DC
BLACK: 12-24 V AC/DC
BROWN: Relay N.C.
GREEN: Relay N.O.
+ -
+ -
Connect to
Accutrol
Device using
factory cable
DEVICE PORT
OR
Power
Source
24 VAC
24 VDC
+
-
+ -
WHITE: GND
