AccuTemp STX-AT-EK, Instructions Manual

Page: 9 / 16

- 7 -
3. Once the temperature has been achieved the base will beep 5 times,
the base heating element will automatically turn off, and the red LED
will turn off.
4. Whenever you remove the kettle from the plugged-in base it will turn
off. This is a safety feature to eliminate the potential for electrical
shock or fire with an exposed hot base.
NOTES:
• You can cancel the selected temperature at any time by pressing
the selected temperature button again. This will shut off the base.
• Fog and condensation will appear in lid and water level view, this is
typical.
• You cannot select a lower temperature once the kettle has heated
to a designated setting until after it has had time to cool down.
• When heating water to the highest temperature (212˚F), the kettle
may vibrate slightly on the base. This is expected.
KEEP WARM MODE
The Enhanced Keep Warm Mode is designed to allow the kettle to
maintain a designated temperature for up to 30 minutes. During this
mode, each time the kettle is removed and replaced, the kettle will be
reheated to the designated temperature. During this mode the kettle
base will beep for 10 seconds each time the kettle is removed from the
base and beep once when it is replaced. It will automatically reheat to
the designated temperature. This mode will be maintained for up to 30
minutes. After approximately 30 minutes the base will automatically turn
off.
1. Fill the kettle as directed (see FILLING THE KETTLE).
2. Place the kettle on the base.
3. Select the desired setting by pressing AND HOLDING one of the six
buttons for 3 seconds. It will beep three times and the button LED
will light up red while the kettle is heating. Once the kettle reaches
the designated temperature, the kettle will beep once and the LED
will change to blinking blue to indicate the Enhanced Keep Warm
Mode is functioning.