2
Before starting the installation process, the slides must be
disassembled into the individual three members. Extend the slide
members and follow the steps as shown in Figure 5. Remove the
intermediate member and then follow steps shown on Figures 11
and 12 to remove the intermediate member.
Drawer Member Mounting
To install the drawer member, use #8 undercut flathead screws.
The use of all the mounting holes is recommended to ensure
maximum load capacity. It is recommended to mount near the
center line of the drawer. See Figure 1.
Mounting Instructions
Figure 4
Drawer Front
Figure 1
Cabinet Member Mounting
Align the cabinet member (outer member) at the proper height so
that the drawer can be inserted with no interference. Install the
cabinet member using #10 hex screws, and ensure slides are
parellel. See Figure 2.
Screw 2
Screw 3
Screw 1
Cabinet
Front
Instop
Cabinet
Figure 2
To modify angle, remove screws 1 and 3 and rotate around
screw 2 to desired angle and reinstall, as shown in Figure 3.
Figure 3
Intermediate Member Insertion
Insert intermediate member into the installed cabinet member,
as shown in Figure 4.
Flat (0°) Mounting 2° Back Angle
4° Back Angle
Drawer Insertion
Before starting drawer insertion, ensure the following:
•
Intermediate member should be nested inside cabinet member
(outer member).
•
Extend intermediate member and pull the locking lever as
shown in Figure 5.
Pull
Figure 5
•
Press down on the locking lever as shown in Figure 6.
If it moves freely, it is unlocked.
WARNING: Locking lever must be unlocked to insert drawer.
Figure 6
Angles may vary by slide length
