Manual Part # 800-1070-001 Rev 10-2016
Page 16 of 20
Programming Parameters
The readout programming parameters are listed below.
Values in
[ ]
are the available range of values that can be entered for that
parameter. Factory defaults are shown in
Bold Red
.
NOTE: Programming parameters are not sequentially numbered due to firmware
differences between measurement systems and the provision for future
enhancements, functions and custom features.
Some Parameters are not applicable to all Digi systems.
Pr 1
– Datum Key
[
0
to + 999.999in
]
or
[
0
to +9999.99mm
]
The programmed value that will be recalled whenever the
DATUM
key is
pressed during normal operation.
Default = 0.00
Pr 2
– Reverse Readings
[
0
or 1
]
This parameter controls the direction of travel (positive vs. negative) when the
encoder is moved.
Default = 0
Pr 3
– Key Lockout
[
0
or 1
]
This parameter controls the operation of the
+
,
-
and
DATUM
keys.
If enabled, (set to 1), these keys will not function and the
LOCK
symbol will
appear on the display. This prevents accidental changes when pressing these
keys during normal operation.
Default = 0
Pr 4
– Readout Resolution
[
1,
2
, 3
or 4
]
This parameter sets the number of places to the right of the decimal point on
the readout.
A value of 1
–
Low
-
will display x.x.
A value of
2
– Normal -will display x.xx
A value of
3
–
High
-
will display x.xxx
Default = 2
NOTE:
Millimeters have a maximum of 2 places (even if parameter is set to 3.)
This setting has no effect when displaying fractions.
Pr 5
– Wake Up Movement
[0.10 to 10mm]
This parameter sets the amount of Stop movement required to automatically
wake up the Readout (when it is turned off or in sleep mode).
Default Value = 0.10mm
