The left side of the first line shows the type of battery you select at the users
setting. The value on the left side of second line sets a charge current and the
value on the right side of second line sets the voltage of the battery pack.
After setting the current and voltage press
Start/Enter key for more than 3 seconds to start
the process.
(Charge current:0.1~7.0A,Voltage:1~8 series)
This shows the number of cells you set up and
the processor detects.‘R:’ shows the numberof
cells found by the charger and ‘S
：
’is the
number of cells selected by you at the previous
screen. If both numbers are identical you can
start charging by press Start/Enter button.If not,
press Batt Type/Stop button to go back to
previous screen. Then carefully check the
number of cells of the battery pack to charge
again.
The screen shows the present situation during
charge process. To stop charging press
BattType/Stop key once.
Charging Lithium battery at balance mode
This is for balancing the voltages of Lithium batteries of the battery park to be
charged. The battery pack to be charged should be connected to the suitable
balance port at the right side of the charger. And also, you need to connect the
battery output plug to the output of charger.
In this mode, the charging process will be different from ordinary charging
mode. The internal processor of the charger will monitor the voltages of each
cell of the battery pack and controls charging current that is feeding to each cell
to normalise the voltage.
The value on the left side of second line sets a
charge current and the value on the right side of
second line sets the voltage of the battery pack.
Charging Lithium Battery
