Accufast P4, User Manual And Operating Manual

Page: 26 / 30

26
6.2 Pen Capping and Storage
Ink cartridge (Pen)
Notch on Pen
Pen Cap
Capped
Pen for
Storage.
1. Remove and clean the pen.
2. Rock the Pen into its capping clip locking the clip over the notch.
3. Store at room temperature.
4. Wipe and wick ink into the lint free cloth at un-cap to get the ink flow-
ing.
Capping frequency depends on the type of ink being used. Typical jet
Fuel brand ink needs to be capped at the end of each day. Other, more
volatile inks should be capped with each stoppage of print that lasts
longer than a few minutes.
6.3 Belt Tracking
Transport belts may wander and begin to rub against the transport tray.
If this happens, stop printing and re-adjust the belt tracking screws.
1. Use a short, wide blade type screwdriver.
2. Locate the belt tracking screws on the entry end of the printer.
3. As the belt turns, slowly twist one screw or the other. Clockwise to
move the belts away from the operator, counterclockwise to move
them toward the operator. Make very slight adjustments and allow
the belt to run into the correct position.
4. Let the Belt run a bit to be sure that it stays.
Caution
Do not Overtighten the belts. Observe the belt speed in in/sec
before and after tracking, they should be the same.