www.accuenergy.com
V: 1.0 Revised: Aug. 2017
AcuRev 1312
24
DIN-Rail Power Meter
Page
Parameter
8
Release Date
9
Model
10
Consumed Active Energy(kWh)
11
Consumed Active Energy Phase A(kWh)
12
Consumed Active Energy Phase B(kWh)
13
Consumed Active Energy Phase C (kWh)
14
Phase A Voltage(V)
15
Phase B Voltage(V)
16
Phase C Voltage(V)
17
Phase A Current(A)
18
Phase B Current(A)
19
Phase C Current(A)
20
Total Current(A)
21
System Active Power(kW)
22
Active Power Phase A(kW)
23
Active Power Phase B(kW)
24
Active Power Phase C(kW)
25
Frequency(Hz)
26
Temperature
27
Meter run time
28
Load run time
---
End
Setting mode:
The settings mode is where the user can perform most configurations for the AcuRev 1312.
Pressing the “SET” key that is located under the meter cover will prompt the user for the meter
password.
For inputting the meter password, users will use the “SCROLL” key to change the value of the
flashing digit. The “SET” key is used to move between digits and to confirm the entered pass
-
word when on the last digit.
Upon entering the correct password, the AcuRev 1312 will direct users to the device address
configuration of the meter or it will redirect the users back to the important parameter display
if the electronic seal is enabled. In this mode there will be an “S” in the top row to indicate that
the meter is in settings mode followed by the setting page number. After a minute of inactivity in
this mode, the meter will be redirected back to the important parameter display. If the “SCROLL”
key is press and held, the meter will also be redirected out of the settings mode.
Note: The default password of the meter is 0000.
In the settings mode, the following operations apply for the keys:
