V: 1.0 Revised: 9-9-2015
Pg: 7
STANDALONE TRANSCEIVER
POWER
The transceiver can easily be powered by connected it to the USB port of a
computer.
The AcuMesh transceiver can also be powered using a standard power supply of
100-240Vac or from an auxiliary wall socket to be powered.
Note: When the transceiver is connected to a gateway, PLC or power meter
through the RS485 port then the transceiver must be powered using the
external power supply.
The AXM-MESH module is directly powered by the Acuvim II series meter that it
is connected to.
LEDs
There are two sets of LED lights on the transceiver that indicate the transceivers
behaviour. The RSSI LED’s indicate the signal strength of the incoming signal.
3 LEDs ON
- Very Strong Signal
2 LEDs ON
- Strong Signal
1 LED ON
- Moderate Signal
0 LED ON
- Weak Signal
The Power LED’s indicates the activity of the transceiver.
The yellow LED indicates the transceiver is transmitting data.
The green LED indicates the transceiver is receiving data, the red LED indicates
the transceiver is powered on or it is communicating (the red light is on when
powered, off briefly during RF transmission).
HARDWARE INSTALLATION
Two types of Transceivers and two antenna choices.
Shop for Power Metering products online at:
1.877.766.5412
www.
PowerMeterStore
.com