4
6.0
CLEANING THE OPTICS
Do not attempt to disassemble the inclined binocular body or focusing mechanisms. These have been
aligned and sealed for protection against dust, dirt, or other particles by our factory technicians. Only
exposed surfaces should require cleaning. To clean the Stereomicroscope:
1.
Blow dust particles from the lens surface with an ear syringe.
2.
Using a lens cleaning solution (available from most camera stores) moisten a cotton swab,
cover the swab with lens paper and carefully clean the lenses and eyepieces. This method may
also be used to remove oily smears and fingerprints, which detract from the image quality.
Glass surfaces should be cleaned very carefully and only when necessary. Use a circular
motion when cleaning glass surfaces.
7.0
LAMP REPLACEMENT
If lamp replacement is necessary, follow these simple instructions:
CAUTION!!! Do not attempt to change the lamp before allowing it to completely cool and
the power cord is unplugged.
7.1 TRANSMITTED (BOTTOM) ILLUMINATION
1.
Unplug the electrical cord.
2.
Carefully lay the instrument on its back and unscrew the base assembly
3.
Remove the old lamp, and insert the new lamp being careful to avoid leaving fingerprints
on the lamp surface.
4.
Reattach the base assembly. Do not operate the microscope unless the base is securely
attached.
7.2
INCIDENT (TOP) ILLUMINATION
1.
Unplug the electrical cord.
2.
Raise the body to the highest position by turning the focusing knob.
3.
Unscrew the two side thumbscrews holding the illuminator housing in place.
4.
Remove the bulb socket from the lamp socket in the lamp housing with a small Phillips
screwdriver.
5.
Detach the bulb and replace it with a new bulb. Leave the new bulb in its envelope while
placing it in the socket to avoid leaving fingerprints on the bulb.
6.
Reinstall the socket into the lamp housing. Reinsert the lamp housing and secure with the two thumb
screws
Replacement bulb: Catalog No. 3367
LIMITED MICROSCOPE WARRANTY
ACCU-SCOPE Microscopes are carefully assembled, inspected and tested by ACCU-SCOPE personnel in
our New York facility. Careful quality control procedures ensure each microscope is of the highest quality
prior to shipment. This microscope is warranted to be free from defects in material and workmanship for a
period of five years from the date of invoice to the original (end user) purchaser. This warranty does not
cover damage caused in-transit, damage caused by misuse, neglect, abuse, or damage resulting from either
improper servicing or modification by other than ACCU-SCOPE approved service personnel. This
warranty does not cover any routine maintenance work or any other work, which is reasonably expected to
be performed by the purchaser. No responsibility is assumed for unsatisfactory operating performance due
to environmental conditions such as humidity, dust corrosive chemicals, deposition of oil or other foreign
matter, spillage or other conditions beyond the control of ACCU-SCOPE INC. This warranty expressly
excludes any liability by ACCU-SCOPE INC. for consequential loss or damage on any grounds, such as
(but not limited to) the non-availability to the End User of the Products under warranty or the need to
repair, work processes. All items returned for warranty repair must be sent freight prepaid and insured to
ACCU-SCOPE INC., 73 Mall Drive Commack, NY 11725 – USA. All warranty repairs will be returned
freight prepaid to any destination within the Continental United States of America. Charges for repairs
shipped back outside this region are the responsibility of the individual/company returning the merchandise
for repair.
ACCU-SCOPE is a registered trademark of ACCU-SCOPE INC., Commack, NY 11725
