3012-LED MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive,
Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
3
SAFETY NOTES
1. Open the shipping carton carefully to prevent any accessory, i.e. objectives or eyepieces, from
dropping and being damaged.
2. Do not discard the molded shipping carton; the container should be retained should the microscope
ever require reshipment.
3. Keep the instrument out of direct sunlight, high temperature or humidity, and dusty environments.
Ensure the microscope is located on a smooth, level and firm surface.
4. If any specimen solutions or other liquids splash onto the stage, objective or any other component,
disconnect the power cord immediately and wipe up the spillage. Otherwise, the instrument may be
damaged.
5. All electrical connectors (power cord) should be inserted into an electrical surge suppressor to
prevent damage due to voltage fluctuations.
6.
For safety when replacing the halogen lamp or fuse, be sure the main switch is off (“O”), remove the
power cord, and replace the halogen bulb after the bulb and the lamp house has completely cooled.
7. Confirm that the input voltage indicated on your microscope corresponds to your line voltage. The
use of a different input voltage other than indicated will cause severe damage to the microscope.
IMPORTANT NOTICE TO PREVENT
DAMAGE TO THE STAGE
To prevent damage to the mechanical stage during transit, the mechanical stage
is locked into place by a metal plate and two screws.
PRIOR TO OPERATION
of the microscope, the metal plate and both screws
MUST
be removed.
An Allen wrench is included in the shipping carton to use for removing the screws.
Failure to remove the metal plate and two screws prior to operation
will cause severe damage to your mechanical stage.
See diagram on next page.
