Sensor Installation
7
Figure 4.
Epoxy Sealant for Three-Wire Connections
WARNIN
Instructions:
NOTE: When temperature is below 50˚F (10˚C), keep resin in a warm place prior to
mixing (e.g., in an inside pocket next to body).
1. Remove guard bag, using caution not to damage inner bag.
2. Grip both edges of bag at the center barrier as shown in the figure to the left
while you flex and wrinkle the bag across the barrier. This will weaken the
barrier.
3. Squeeze the CLEAR SIDE of the resin, forcing the resin through the center
barrier.
4. Mix thoroughly to a uniform color by squeezing contents back and forth 25-30
times.
5. Squeeze resin to one end of bag, and cutoff other end.
6. Slowly insert connection into sealing pack until it fits snugly against the opposite
end.
7. Twist open end of bag and use tie wrap to close it off, or wrap open end of bag
with vinyl electrical tape (not included) and position the taped end up until the
resin jells.
Make sure that the
end of sensor cable
sheathing is submerged
in sealant
3 Wire
Sensor
Connection
sensors\epxy3w.eps
To sensor
To console
Tie wrap
Wire nuts
