C
OMPLIANCES
– 4 –
T
HIS
DEVICE
IS
INTENDED
ONLY
FOR
OEM
INTEGRATORS
UNDER
THE
FOLLOWING
CONDITIONS
:
1.
The antenna must be installed such that 20 cm is maintained between
the antenna and users, and
2.
The transmitter module may not be co-located with any other
transmitter or antenna.
3.
For all products marketed in the US, OEM has to limit the operation
channels in CH1 to CH11 for 2.4 GHz band by supplied firmware
programming tool. OEM shall not supply any tool or info to the end-user
regarding to Regulatory Domain change.
As long as the three conditions above are met, further transmitter tests will
not be required. However, the OEM integrator is still responsible for testing
their end-product for any additional compliance requirements required with
this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions cannot be met (for
example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
E
ND
P
RODUCT
L
ABELING
This transmitter module is authorized only for use in device where the
antenna may be installed such that 20 cm may be maintained between the
antenna and users. The final end product must be labeled in a visible area
with the following: “Contains FCC ID: V8YFIXHI623A000W”.
M
ANUAL
I
NFORMATION
T
O
THE
E
ND
U
SER
The OEM integrator has to be aware not to provide information to the end
user regarding how to install or remove this RF module in the user's
manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/
warning as show in this manual.
