Accton Technology VS4512DC, Management Manual, Page: 236 / 334

Command Line Interface
4-90
Default Setting
Enabled for all ports
Packet-rate limit: 500 packets per second
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When broadcast traffic exceeds the specified threshold, packets above that
threshold are dropped.
• This command can enable or disable broadcast storm control for the selected
interface. However, the specified threshold value applies to all ports on the
switch.
Example
The following shows how to configure broadcast storm control at 600 packets per
second:
clear counters
This command clears statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit / port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Value: 1)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base
value for displayed statistics to zero for the current management session.
However, if you log out and back into the management interface, the statistics
displayed will show the absolute value accumulated since the last power
reset.
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast packet-rate 600
Console(config-if)#