ACCO Brands TruSens Z-2000, Owner'S Manual

Page: 8 / 11

15 14
REPLACING UV BULB
WASHING THE PREFILTER
1. The indicator will glow red when it is time to
replace the UV bulb.
2. Remove HEPA filter drum (Fig. A), and use a
screwdriver to remove the screw securing the UV
housing (Fig. I).
3. Gently remove the UV housing (Fig. J) and
disconnect the UV bulb from the socket (Fig. K).
4. Release carriage from the UV bulb (Fig. L).
5. Secure carriage to new UV bulb (on page 12)
(Fig. M) and connect UV bulb into purifier (Fig N).
6. Replace the UV housing and use a screwdriver to
tighten the fastening screw.
7. Once the purifier is powered-on, hold the Reset
button until the indicator turns white.
1. The Carbon indicator will glow red when it is time to replace
the Carbon layer.
2. Gently peel away the Prefilter from the fastener strips (Fig. E).
3. Gently peel away the used Carbon layer from the fastener
strips (Fig. F).
4. Wrap a new Carbon layer around the filter drum and attach
to the same fastener strips (Fig. G).
5. Replace the Prefilter by wrapping it around the Carbon layer
and attach to the fastener strips (Fig. H).
6. Once the purifier is powered-on, hold the Reset button until
the red Carbon indicator turns off.
1. We recommend that you visually inspect the Prefilter every
month, and clean as needed. At minimum, you should
hand wash the Prefilter every time you change the Carbon
filter.
2. Gently peel away the Washable Prefilter from the fastener
strips (Fig. E).
3. Gently rinse with running water – allow Prefilter to air dry
before re-installing.
4. Replace the Prefilter by wrapping it around the filter drum
and attach to the fastener strips (Fig. H).
Note: Carbon filter 3-pack (on page 12) will cover 3 Carbon changes
between replacing the entire HEPA drum filter assemly (on page 13).
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. L
Fig. J Fig. K
Fig. M Fig. N
REPLACING CARBON FILTER