12
www.acclaimlighting.com
9r01
P080
5h01
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP
UP
UP
UP
UP
UP
UP
MENU
MENU
MENU
MENU
MENU
MENU
MENU
(2 seconds)
(2 seconds)
CONFIGURATION
The Pixel Driver 1 controller can drive up to 16.4’
(5m) of Flex Tube Pixel tape. The behavior of the
connected Flex Tube Pixel is determined using
the control menu.
PIXEL DRIVER 1
MENU NAVIGATION
Use the three control buttons to navigate around
the menu and alter settings as necessary. Press
and hold the
MENU
button for two seconds to
enter and exit edit mode within a menu option.
Note: You must exit from edit mode within one menu
option before you can move to a different menu option.
MENU
UP
DOWN
DMX
Pixel Driver 1
GND
Made in P.R.C.
IP20
GND
GND
GND
SPI OUTPUT
Data
NC
+12-24V
D
C
IN
D
M
X
IN
10
A
M
ax
.
D
M
X
O
U
T
+12-24V
Data–
Data–
Data+
Data+
8888
MENU
: Press and hold for 2 seconds
to enter/exit edit mode for the
current menu option.
UP
/
DOWN
: Use to move between
menu options and to change values
within a menu option in edit mode.
This bar and
dot flash
whenever in
edit mode
This dot flashes
to indicate
a valid DMX
input
This bar and dot flash
whenever in edit mode.
Press and hold MENU for 2
seconds to enter/exit edit
mode.
MENU OPTIONS SUMMARY
(see page 14 and page 15 for details)
A001
- DMX base address
9r01
- Segment grouping (determines pixel size)
P060
- Defines total pixels under control
Sh01
- Self test (see page 15)
CH03
- Channels per segment (
CH03
for RGB,
CH04
for RGBW)
IC01
-
Do not change
