Accessmatic Fox1000 Pro, User Manual

Page: 70 / 78

Opening your life
P
RO
1000
29
MAINTENANCE
1. No particular maintenance is required for the electronic board.
Check the door at least twice a year if it is well balanced, and all parts are in good working order.
Check the recoil sensitivity at least twice a year, and adjust if necessary.
Make sure that the safety devices work effectively (light beams, etc.)
2. Bulb replacement:
NOTICE: Make sure that the power supply has been disconnected before replacing the bulb, and make sure that the voltage of the new
bulb corresponds to the used voltage and the power is 25 watts.
Remove the screw from the lamp cover. Remove the lamp cover and then unscrew the L.E.D. bulb. Install the new L.E.D light and lamp
cover.
3. Before installing a caution light, make sure the range is within 5 watts.
Introduction of another terminal and applications
1. Available O / S / C interface (Fig26, Fig. 27)
Add a new O / S / C button to open or close the door.
2. Flashing light function (Fig26, Fig. 27)
There is an interface corresponding to this function and it provides a flashing light voltage of 24V-35V. Connect the flashing light to
24V-28VDC, current ≤ 100mA. When using 220 VAC flashing lights, please use the required adapter and wiring.
3. Protection of the door of passage (SD) (Fig26, Fig. 27)
This feature ensures that the door cannot be opened unless the small through door is closed. The door panel will not be damaged.
4. As for the maintenance alarm function, if the LED light blinks rapidly 10 times means the door lost balance, it is recommended to
perform the maintenance of the garage doors. "Check" the status, or "re-memorize" the travel limit after the maintenance alarm
warnings.
Note: A heavy duty door can affect the life of the automatic opening motor due to incorrect loads, it will void the warranty.