Page
2
of
17
Copyright © Access-IS 2020
Warnings
This manual contains important information regarding the installation and operation of the VAL100. For safe
and reliable operation of the imager, installers must ensure that they are familiar with, and fully understand, all
instructions contained herein.
Warranty
Access Ltd warrants that this product shall be free from defects in workmanship and materials for a period of
one year from the date of original purchase. If the product should fail to operate correctly in normal use during
the warranty period, Access will replace or repair it free of charge. No liability can be accepted for damage
due to misuse or circumstances outside Access' control. Access will not be responsible for any loss, damage
or injury arising directly or indirectly from the use of this product. Access' total liability under the terms of this
warranty shall in all circumstances be limited to the replacement value of this product.
(Non- RFID version)
This product meets the requirements of the following directives and carries the CE marking
accordingly; 2014/35/EU Low Voltage Directive, 2014/30/EU EMC Directive, 2015/863/EU RoHS 3
Directive.
(RFID version)
This product meets the requirements of the following directives and carries the CE marking
accordingly; 2014/53/EU Radio Equipment Directive, 2015/863/EU RoHS 3 Directive.
Compliance Statement (United States)
Supplier’s Declaration of Conformity
47 CFR §2.1077 Compliance Information
Unique Identifier: VAL100 On-board Validator Barcode/NFC & RFID/cEMV Payments
Responsible Party
– US contact information:
MONICA GLOZER
ACCESS-IS
ROEDL LANGFORD DE KOCK, LLP
110 SOUTH TOWER
225 PEACHTREE ST. NE
ATLANTA
GA 30303
Email:[email protected]
FCC Compliance Statement (Products subject to Part 15):
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The RFID version contains FCC approved Access-IS Module FCC ID: ZERCPM01
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissions from digital apparatus set out in
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de la classe A prescrites dans le règlement sur le brouillage radioélectriques publié par
le ministère des Communications du Canada.
The RFID version contains approved module IC: 9653A-CPM01
