Page
2
of
18
Copyright © Access-IS 2019
Warnings
This manual contains important information regarding the installation and operation of the BGR750 boarding
gate reader. For safe and reliable operation of the imager, installers must ensure that they are familiar with,
and fully understand, all instructions contained herein.
Warranty
Access Ltd warrants that this product shall be free from defects in workmanship and materials for a period of
one year from the date of original purchase. If the product should fail to operate correctly in normal use during
the warranty period, Access will replace or repair it free of charge. No liability can be accepted for damage
due to misuse or circumstances outside Access' control. Access will not be responsible for any loss, damage
or injury arising directly or indirectly from the use of this product. Access' total liability under the terms of this
warranty shall in all circumstances be limited to the replacement value of this product.
(Non- RFID version)
This product meets the requirements of the following directives and carries the CE marking accordingly;
2014/35/EU Low Voltage Directive, 2014/30/EU EMC Directive, 2015/863/EU RoHS 3 Directive
Warning: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment
may cause radio interference.
(RFID version)
This product meets the requirements of the following directives and carries the CE marking accordingly;
2014/53/EU Radio Equipment Directive, 2015/863/EU RoHS 3 Directive
FCC Compliance Statement (United States)
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier:
Access BGR750 Flatbed 2D BCBP Boarding Gate Reader with optional RFID and OCR
capability
Responsible Party - U.S. Contact Information
MONICA GLOZER
ROEDL LANGFORD DE KOCK, LLP
1100 SOUTH TOWER
225 PEACHTREE ST. NE
ATLANTA
GA 30303
Email : [email protected]
FCC Compliance Statement (Products subject to Part 15) :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
The RFID version contains FCC approved Access-IS Module FCC ID: ZERNSM01.
