BX5 & CX5 models
795mm
AX5 model
795mm
WATERING
P13
x
y
x
x
x
y
y
y
Bend bracket
down slightly
Use black strap through
hole to fix pipework to bracket.
z
'L' brackets need to be fitted inside the frame.
x - Use a nut and bolt to fix to the hole
y - Use the bolt hole on the centre staging rail
2
Right hand watering entry:
The double tee is configured for fitting to
the left hand end. To change to r/h entry,
twist the tee through 180 degrees.
4
Use the black straps to secure the watering system to the
'L'' shaped brackets and then strap the pipes to the end of
the frame using the hole in the leg. The long strap is used
to secure the pipe to the top leg at position ‘Z’ (BL5 ).
Fit the black grommet (from pack SCREW-H1) into the
unused irrigation hole at the opposite end of the unit.
NOZZLE ASSEMBLY
AW5
(I-W-NA
)
BW5/CW5
2
4
GREY PIPES
AW5
BW5/CW5
4
6
ENTRY FITTING:
Nipple, adaptor, washer and
brass elbow
1
10MM BOLTS & NUT
AW5
BW5
2
4
Located in pack: I-SP-2
PARTS NEEDED:
SINGLE TEE (KET)
2
BLANKING PLUG (KEB)
4
‘L’ BRACKET
AL5
BW5/CW5
2
4
BLACK STRAPS
(short)
BW5/CW5
(long)
6
1
DOUBLE TEE (I-W-CP)
1
TIP:
Dip the end of the
grey pipe in water. For a
better fit, twist the pipes
as they are inserted.
Nozzle strapped to ‘L’
bracket
Fit the washer
onto the thread of
the adaptor, and
then fit the nipple
1
Push the
assembly
through the hole
from the inside
Screw the brass
elbow onto the
protruding thread
from the outside
Choose which end you would like the watering inlet.
Inlet and link pipe
Double tee
Blanking grommet
Bend bracket down
y
'L' brackets need to be fitted inside the frame.
x - Use a nut and bolt to fix to the hole
y - Use the bolt hole on the centre staging rail
2
Fit the irrigation
system as shown.
The grey tubes push
into the black
fittings. Ensure the
open face of the
grey nozzle faces
into the frame.
3
Inlet and link pipe
Double tee
Blanking grommet
1
Choose which end you would like the watering inlet.
Twist here for
r/h end fitting
Finished tee for
r/h end fitting