Accelleron A200-H, Assembly Instructions Manual

Page: 15 / 24

Assembly Instructions / A238-H.. - A240-H..
4 Installing the turbocharger / 4.3 Placing and aligning the turbocharger on the bracket
© Copyright 2022 Accelleron Industries. All rights reserved. HZTL455311P0042_EN Rev. B May 2022
u
Make sure that the position of the oil inlet of the bracket matches the oil inlet hole in the bearing
casing.
u
Make sure that the O-rings are placed correctly in the slots.
Step C - Placing the turbocharger
Fig. 9: Placing the turbocharger on the bracket
1. Lightly lubricate the hole in the bracket, into which the centering bush (04) is inserted, with screw
grease.
2. Position threaded rod with centering bush into bracket and insert until stop.
3. Carefully lower turbocharger onto bracket and position using the centering bush (04) located in
the bracket.
4. Check dimension X. If dimension X is not reached, the turbocharger must be lifted up from the
bracket and realigned.
The values X and L depend on the length of the threaded rod and must be specified by the user.
5. Using the hexagon, screw the threaded rod into the bracket up to dimension L. If dimension L is
not reached or the threaded rod jams while being screwed in, the threaded rod must be loosened
by no more than ½ revolution (this will loosen the centering bush which may have jammed the
rod). Then continue screwing in. If dimension L is not reached, loosen the screw connection,
carefully take the turbocharger off the bracket and repeat the procedure starting with Step 1.
u
Comply with the steps for fastening the turbocharger:
¡
Fastening the turbocharger with a clamping nut → 14
¡ Fastening the turbocharger with a standard nut → 16
Page
13
/
21