Customer Support: 1-800-377-4532
Revised: June 15, 2012 9:04 AM
Step 2
Remove the seat and seat post assembly.
Step 3
Locate the front-rear “transfer chain”. It is the middle of the three drive chains. Locate the master link, then using a
pair of needle-nose pliers, slide off the slotted faceplate
Step 4
a) Locate the controller compartment, located under the battery. Remove the three Phillips-head screws holding the
side plate onto the left side of the compartment.
b) Inside the controller compartment, disconnect the
motor connector from the silver controller box. It has a
large white plug and two wires, green and blue. Cut any
cable ties holding the motor wire to the frame, then coil
the wire so it doesn’t get in the way later.
1
2
3
