Acceed IP101, Installation Manual And User'S Manual

Page: 12 / 17

8
Incoming address & Remote IP address
= Incoming address
For example, if Remote IP address is 192.168.0.254. It will allow TCP connection from all even addresses in subnet
192.168.0.xxx but not the odd addresses. If Remote IP address is 192.168.0.127, it will allow connection from
address range from 192.168.0.0 to 192.168.0.127. Note that this is a very simple address filtering, it does not exclude
all possible address that is not desired. For the UDP connection, the
Remote IP address does not work as address filter.
It should be set exactly as the IP address of the other end of connection.
Baud rate:
Data/Parity/Stop:
Flow control:
Connection mode:
Enter to show a list of predefined values. Using arrow key to select value and enter to set the value. There are two
connections mode, client and server. To setup serial tunneling, user has to set one IP SERIAL SERVER to server and
the other to client mode. The connection mode has to set to server mode for the host base connection.
TCP/UDP port:
There are two fields in this line. The first field selects TCP or UDP protocols. The second field chooses the port
number of the connection. A predefined TCP port, 5300, is reserved for the heartbeat. When using UDP protocol, there
is no guarantee that the other side of the connection will receive data. For more reliable connection, please use TCP
connection.
There are five buttons, “
Save ”, “ Default ”, “ Running ”, “ Reset ”, and “ Status ”. User can use TAB, Backspace, or arrow
keys to move cursor to the button’s position, then press enter. The “ Save ” action store configuration data to flash. User
must reset the device for the stored configuration data to take effect. The “ Default ” button restore the editing configuration
data to default. The “ Running ” button restores the editing configuration data to the value that stored in the flash. For the
edited value to take effect, user need to save the configuration data, then reset the device. Enter the “ Status” , a window will
show up. It displays number of packet that Ethernet has transmitted and received. And the number of the character the
serial port has transmitted and received.
3.3 Pin Assignment
Pin RS-232 RS-422 RS-485
1 DCD RXDA(-)
2 RXD RXDB(+)
3 TXD TXDB(+) DATA B(+)
4 DTR TXDA(-) DATA A(-)
5 GND
6 DSR CTSA(-)
7 RTS CTSB(+)
8 CTS RTSB(+)
9 RI RTSA(-)