25
AEC-67160 Ultra160 SCSI Adapter
4.2.2 Windows NT Environment
Driver installation is required when it is the First Time to Setup
Windows NT into the System
AEC67160.SYS is designed for Microsoft Windows NT miniport
drivers. It allows driver connects to SCSI devices (which support by
Microsoft)
1.Insert Windows NT boot disk and booted from floppy disk.
(If booted from CD-ROM or installed from hard disk, please press
“F6” for the first booting screen)
2.Follow the Windows NT setup procedure.
3.Press “S” to skip mass storage devices detection.
4.Press “S” to specify additional SCSI adapter.
5.Move the highlight bar to “
the other
” and press “Enter”.
6.Then insert the AEC-67160 DISK into floppy drive A.
7.The ACARD Miniport driver should be highlighted at this stage.
Press “Enter” to proceed.
8.NT should now recognize the ACARD Miniport driver and the
SCSI hardware. Please follow the Microsoft Windows NT
installation.
9.Setup program will ask to insert driver disk, please insert DISK
into floppy drive A.
Install Driver for Windows NT
When Windows NT had been installed and you want plug the
ACARD SCSI device on the Windows NT system, please use the
ADD SCSI Controller method which states at below.
