PG 3
LEG ASSEMBLY
1.
Carefully lay the completed 81518 top section on its side
- ladder rungs up as shown in
figure 1.
2.
Position one of the Couple Plates as shown in
figure 2.
Slide the plate over the leg and line up the holes.
NOTE:
Coupler Plate must line up with the round holes and not the
oval holes.
3.
Position one of the Brackets as shown in
figure 3
. The
bracket should be bolted to the Coupler Plate so that it runs
horizontal when the tripod is sitting upright.
4.
Use one
2 3/4” bolt and lock nut
to secure both the
Bracket and Coupler Plate.
1
COUPLER PLATE
(PN 14061.300)
2
2 3/4” BOLT, LOCK NUT -
WRENCH TIGHTEN
BRACKET
(PN 14061.400)
3
5.
Position the 12’ Ladder Assembly as shown in
figure 4.
6.
Slide the Assembly into the Coupler Plate and secure
with one,
2 3/4” bolt and lock nut.
(see figure 5)
4
12’ LADDER
ASSEMBLY
(PN 14063.1100)
2 3/4” BOLT, LOCK NUT -
WRENCH TIGHTEN
5
7.
Carefully rotate the tripod assembly to gain access to one
of the legs.
8.
Slide another Coupler Plate on the Leg and line up the
round holes as shown in
figure 6.
9.
Position one Bracket as shown in
figure 6
and secure
using one
2 3/4” bolt and lock nut.
COUPLER PLATE
(PN 14061.300)
BRACKET
(PN 14061.400)
2 3/4” BOLT, LOCK NUT -
WRENCH TIGHTEN
6
