15
P a i n t in g In s t r u c t io n s
Notes on Painting AC Schnitzer Components
Before painting, all AC Schnitzer bodystyling components must be checked for fit on the vehicle (e.g. contact
surfaces/contours).
Any retouching work (e.g. sanding of contact surfaces/contours) must be carried out before painting !
The quality and durability of the paint on a component depends on the preparation and external influences, and cannot
therefore be compared with that on any other body element.
To avoid distortion/deformation during working and drying, AC Schnitzer components should be placed on a
corresponding jig.
Note !
The painting instructions of the paint manufacturer must be followed !
Painting Steps:
1. Cleaning:
Plastic cleaner / silicone remover
2. Tempering:
30 min
. at max. 40° C
object temperature
3. Inspection:
Edges and seams on surface (pores etc.), sand down if necessary
4. Sanding:
2K stopper P220
– P280 (dry), complete component P400 – P600 (dry)
5. Masking off:
Contact surfaces, TÜV marking, rating plates
6. Cleaning:
Silicone remover
7. Filling:
2K HS filler
8. Drying:
1 hour at
max. 40° C
object temperature, component should remain in drying
cabinet overnight
9. Removal:
Masking tape on rating plates, contact surfaces and TÜV marking
10. Sanding:
P800 (dry)
11. Cleaning:
Silicone remover
12. Masking off:
Contact surfaces
13. Painting:
Observe technical data and painting instructions from paint manufacturer
14. Drying:
1 hour at
max. 40° C
object temperature, component should remain in drying
cabinet overnight
Painting Instructions Issue: 12/2019
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
