Technical Information
ƵƵ
Notes:
If the unit is turned off while the blow function is activated, the indoor fan will run at low speed for 2 minutes with the word “BLOW”
displayed on the LCD.
Blow function is not available in FAN or HEAT mode.
3.11 Other Functions
a. Lock
While the unit is OFF, press
S
or
T
at the same time for 5 seconds on the remote controller. Doing so will enable lock mode and
a icon will appear on the LCD. To unlock, press these two buttons simultaneously for 5 seconds. While the unit is locked, no
response will be gained by pressing any other combination of buttons.
b. Memory
While the unit is OFF, press the MODE and
S
buttons simultaneously for 5 seconds to switch between memory ON and
memory OFF. Once activated, memory will be displayed. Memory allows the user to set the following; ON/OFF, Set Temperature,
Mode, Set Fan Speed and Lock Function.
4. Installation and Dismantlement
4.1 Connection of the Signal Line of the Wired Controller
•
Open the cover of the electric control box on the indoor unit.
•
Place the single line of the wired controller through the rubber ring.
•
Connect the signal line of the wired control to the 4-pin socket of the indoor unit PCB.
•
Tighten signal wire with zip ties.
•
Communication distance between the main board and the wired controller can be up to 66 feet. Standard distance is 24 feet.
4.2 Installation of the Wired Controller
No.
1
2
3
4
5
Name
Socket box embedded
in the wall
Soleplate of the
Wired Controller
Screw M4X25
Front Panel of the
Wired Controller
Screw ST 2.9X6
Summary of Contents for AWH18QD-D3DNA1G/O
Page 2: ......