30
2-9 Charging the Remote Control
2. Start-Up Guide
Radio Charger
Charging
Indicator
LED
Charging Jack
WARNING: Only use the supplied charger to charge the controller when using the
supplied batteries or the following:
- 1200mAh to 2200 mAh Ni-MH or Ni-Cd ‘AA’ Rechargeable Batteries
Using the remote control charger with alkaline batteries installed can damage the con-
troller. Do not use the charger if alkaline batteries are installed in the controller.
1. Plug the transmitter charger into a 110v AC wall socket.
2. Plug the connector from the charger into the charging jack on the transmitter. The
charging indicator LED, located on the side of the transmitter, will illuminate green
indicating the charger is charging. Once the transmitter is fully charged the charging
indicator LED will turn off .
3. The charging rate of the charger is 150mAh. When using the 1200mAh batter-
ies that are supplied, the radio requires an 8 hour charge when fully discharged
(1200/150=8). If using 2200mAh batteries, it will take approximately 15 hours to
charge (2200/150=14.6).
It is recommended to leave the remote controller charging when not in use.
