Abus TVVR33004, User Manual

Page: 96 / 571

Configuration
96
Live view
Note
The following settings are available for the live
view.
Open the main menu and click on Configuration. Then
click on Live View:
The following settings are available in the General tab:
Video Output
Interface HDMI
Select the connection where the
settings are changed.
Live View
Mode Various camera layouts
1x1, 2x2, 1+5, 1+7
Dwell Time Switching time between the
individual cameras during auto-
switch.
Enable Audio
Output Activates the audio output
(VGA/HDMI/BNC) for the live view.
Display status
bar Activate/deactivate the status bar.
Event Output Allocate monitor for the output of
events.
Full Screen
Monitoring Dwell
Time The number of seconds for which
the event will be displayed on the
allocated monitor.
Post Event
Display Time The number of seconds for which
the pop-up window should be
displayed in the event of an alarm.
Note
VGA monitor connected:
If a VGA monitor is connected, it will be
recognised automatically when the device is
started up. The main video signal will be displayed
on the monitor.
HDMI monitor connected:
If no HDMI cable is connected to the monitor
when the device is started up, the main video
signal will be emitted at the main VGA connection.
Connect the HDMI cable, shut down the recorder,
then restart again after 10 seconds to perform
automatic detection.
Setting the camera output
You can display a maximum of five (TVVR33004) or nine
(TVVR33008) cameras simultaneously in the live view.
1. Click on the View tab:
2. Select the display mode.

1 x 1

2 x 2

1 + 5

1 + 7

3 + 3
3. Use the navigation keys to allocate the camera
signal required to the corresponding screen section.

The X setting means that this particular camera
is not being displayed.
4. Click on Apply to apply the setting.