Abus TVVR33004, User Manual

Page: 122 / 571

Fault rectification
122
Fault rectification
Before contacting the Service department, read the following information to determine the possible cause of any fault.
Fault Cause Solution:
No power Power cable not connected Connect the power cable properly to the
socket
Power switch at OFF Set power switch to ON
No power supplied from socket If necessary, use another device at the
socket
No picture The screen is not set to receive Set correct video input mode, until an image
is received from the recorder
Video cable is not connected properly Connect the video cable properly
The connected monitor is switched off Switch on monitor
Hard disk drive not functioning Connection cable is not connected properly Connect the cable properly
Hard disk drive faulty or incompatible with the
system Replace the hard disk drive with a
recommended hard disk drive
USB connection not functioning Device is not supported Connect correct USB medium, USB 2.0
USB Hub was used Connect USB medium directly
Network access not possible. Network cable connection loose Insert network cable.
Network settings (DCHP, IP address etc.)
incorrect Check and, if necessary, correct the network
configuration.
Recording is not possible No HDD, or HDD not initialised Install and initialise hard disk drive
Sudden switch-off The internal temperature of the device is too
high
Clean the device and/or remove any objects
impeding the ventilation
Cleaning and care of the device
Note

The device is maintenance free.

Protect the device against dust, dirt and damp.