Abus FUBE50061, Installation Instructions And User Manual

Page: 57 / 188

EN 25
9. Operation
Arming
To arm your Secvest wireless alarm panel, turn the key to the right as far
as it will go. This causes the locking nose to press the left button (11).
The red LED on the right (14) will flash briefly, indicating that the wireless
key switch has transmitted the information to the panel and there is
sufficient battery capacity available. If the LED does not light up during
battery operation, check the charge status of the batteries.
Once the exit delay period has passed, the wireless alarm panel is armed
and transmits information about its armed status to the wireless key switch.
The wireless key switch indicates this by causing the red LED on the right
(14) to flash for around 6 seconds. The wireless key switch will beep twice.
Disarming
To disarm your Secvest wireless alarm panel, turn the key to the left as far
as it will go. This causes the locking nose to press the right button (12).
The green LED on the left (13) will flash briefly, indicating that the wireless
key switch has transmitted the information to the panel and there is
sufficient battery capacity available. If the LED does not light up during
battery operation, check the charge status of the batteries.
The wireless alarm panel is now disarmed and transmits information about
its disarmed status to the wireless key switch. The wireless key switch
indicates this by causing the green LED on the left (13) to flash for around
6 seconds. The wireless key switch will beep once.
Note
The wireless key switch will beep eight times if it is unable to receive status
information from the wireless alarm panel.