G100-XXL is a main member of digital-chargers from
. It represents today’s new technology for 12.8V(4s) ~
34.8V(12s)
Li-Ion/Polymer/FePo4
battery
pack
charging.
G100-XXL
programmed 3 auto stages ( Ip-Im-Um) charging process
，
It is designed for
3~25Ah Li-Ion/Polymer/LiFePo4 battery pack. Stage “Ip” is a pre-charge
function for deep discharged battery pack, this is helpful for battery’s cycle life.
When the battery recovered by pre-charge small current, stage “Im” will give
bulk current charging. Then, “Um” stage is followed, the output voltage is
limited on 14.4V(for 4S LiFePo4) or 16.8V(for 4S Li-ion/polymer), until the
charge current declined to 0.4A. At this stage, the battery is charged
completely and the charger will cut off output automatic.
Further, G100-XXL can display the charging process, indicate the battery
capacity from 25% to 100% timely. This is helpful for user.
For more safety, G100-XXL will inter protection mode when the battery
polarity reversed our the output connectors shorted.
Specification for G100-XXL
Input Voltage
100-240VAC
，
50-60Hz
Input Current
1.6A
Back current drain 1
）
<1mA
G100-12LF
G100-24L
G100-36L
G100-36LF
Charge voltage limit
14.4V+-1%
29.4V+-1%
42V+-1%
43.2V+-1%
Bulk charge current
4.5A+-5%
2.8A+-5%
1.8A+-5%
Operate Temperature
-20
℃
~50
℃
Cooling
Natural convection. Do not cover the charger.
Charge principle
Auto 3 stages: Ip-Im-Um
Cut-off when charge finished.
Battery type
From 12.8V(4s) to 38.4V(12s), Li-ion/Polymer/LiFePo4
Battery capacity
3-25Ah
Size
170X70X51mm
Enclosure
IP54 (
Dust protected, Water splashing resistance)
Weight
400g
Display Panel
How to use:
1.
Connect the AC cord to the socket, The “power” lamp will light on solid.
2.
Connect positive charger clip (red) to positive battery terminal, the black clip
to negative. (You can use other dc plugs to connect battery), the
“25%~100%” lamps will light on flowing. If the battery polarity reversed or
output shorted, “Warning” lamp will flashing, please check the setup.
3.
Depend on the charged capacity, 25%~100% lamps will lights up solid
sequence, until the battery is fully charged. Then you can power off the
charger and disconnect the battery or you can charge a new battery if you
need.
The table shows the duration of 80% state charged for an empty battery.
Battery cap.
G100-12LF
G100-24L
G100-36L
3.2Ah
Not recommend
1.5 hours
2 hours
7.0Ah
2 hours
3 hours
4 hours
12Ah
3 hours
5 hours
7 hours
25Ah
6 hours
10 hours
13 hours
Charging process indicator:
Indicate battery capacity from 25% to 100% when
charging.
All lamps flashing means battery polarity reversed or
output shorted.
All lamps are “off” means no battery.
Power on
(When
AC
input OK)
Shenzhen ABT
Electronics CO.,LTD
