NOTE: The two holes required to connect the padbolt hasp for each door have not been pre-punched, to
allow for proper alignment. Position the hasp centrally over the padbolt shaft, and drill 3mm holes and
secure with screws.
NOTE: NUTS AND BOLTS (SUPPLIED) MAY BE USED
INSTEAD OF POP RIVETS (SUPPLIED) BY SIMPLY
ENLARGING THE HINGE HOLE SETS IN THE JAMB
USING A 4MM DRILL BIT
PAGE 18
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTION - MODEL: 08081H 17/09/12
Absco EZISLIM Shed
Model: 08081H HIGHSLIM
FINAL CONSTRUCTION
CONNECT DOOR TO FRONT FRAME
FOR INTERNAL LOCKING
DOOR BOLT AND PAD PLATE CAN BE
RE-LOCATED TO INSIDE OF DOOR
