Absco Industries
Assembly Instruction Manual
ABSCO BUSH RANGER SHED
MODEL: 3023BRK
3.00mW x 2.26mD x 2.30mH
Model: 3023BRK
09/10/2018
1.1
35
ROLLER SHUTTER ASSEMBLY SUPPORT PHOTOS
1
To begin remove the tape that is holding the back
cover of the roller shutter unit.
1
Cut side guides to length for the Bush Ranger
Shed. Mark 1820mm from one end and cut to
length. Shown below are the offcuts.
2
Take the two “end plate legs” and slide them onto
the roller door unit as shown. These will be used to
fi t the runners.
3A
Take your newly cut to length guides and slide
them over the edge of the roller shutter and end
plate leg.
3B
Pre-drill with the 3mm drill bit through the guide
and the end plate legs.
Take a 45mm long Tek screw and fasten through
both of these.
Do not advance the screw all the way down yet
because we will use this screw to fasten it to the
inside frame of the shed.
2
3
A
B
